BLUECOLLAR
May 10th, 2001, 07:37 AM
For those of you that are riding around "sideways", theres a way to level out your ride.....WITHOUT SPENDING ANY MONEY!
Measure all 4 corners and write down your measurements.(Ford says 1/2" is out of specs)
You probably want to bring down the higher side to around the reading of the low side.
NOTE:A "HIGH" FRONT WHEEL DRIVE CONTINENTAL IS HARD ON THE INNER C.V. JOINTS.(vibration on acceleration)
MAKE SURE YOU TURN OFF THE SUSPENSION SWITCH!
Theres 2-5/16 screws that holds the metal arm to the sensor in the front. Loosen the "pivot" screw first, then the other. Its very hard to explain which way to move it, so move it one way,turn on switch and measure the result. It may go the opposite way, so reverse the procedure.
Measure all 4 corners and write down your measurements.(Ford says 1/2" is out of specs)
You probably want to bring down the higher side to around the reading of the low side.
NOTE:A "HIGH" FRONT WHEEL DRIVE CONTINENTAL IS HARD ON THE INNER C.V. JOINTS.(vibration on acceleration)
MAKE SURE YOU TURN OFF THE SUSPENSION SWITCH!
Theres 2-5/16 screws that holds the metal arm to the sensor in the front. Loosen the "pivot" screw first, then the other. Its very hard to explain which way to move it, so move it one way,turn on switch and measure the result. It may go the opposite way, so reverse the procedure.